Changing Lanesense Status; Parkview Rear Back Up Camera - Jeep 2022 CHEROKEE Owner's Manual

C L S S
HANGING ANE ENSE TATUS
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning
zone sensitivity (early/late) that you can configure
through the Uconnect system Ú page 150.
NOTE:
When enabled the system operates above

37 mph (60 km/h) and below 112 mph
(180 km/h).
The warnings are disabled with use of the turn

signal.
The system will not apply torque to the steering

wheel whenever a safety system engages
(Anti-Lock Brakes, Traction Control System,
Electronic Stability Control, Forward Collision
Warning, etc.).

PARKVIEW REAR BACK UP CAMERA

Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of your
vehicle whenever the gear selector is put into
REVERSE. The image will be displayed in the
touchscreen display along with a caution note to
"Check Entire Surroundings" across the top of the
screen. After five seconds this note will disappear.
The ParkView camera is located on the rear of the
vehicle above the rear license plate.
NOTE:
The ParkView Rear Back Up Camera has program-
mable modes of operation that may be selected
through the Uconnect system Ú page 150.
When the vehicle is shifted out of REVERSE (with
camera delay turned off), the rear camera mode is
exited and the previous screen appears. When the
vehicle is shifted out of REVERSE (with camera
delay turned on), the camera image will continue to
be displayed for up to 10 seconds unless the
following conditions occur: the vehicle speed
exceeds 8 mph (13 km/h), the vehicle is shifted
into PARK, the vehicle's ignition is placed in the
OFF position, or the touchscreen button "X" to
disable the display of the Rear View Camera is
pressed.
Manual Activation Of The Rear View Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn the
Rear View Camera system on.
NOTE:
If the Rear View Camera was manually activated,
the timer will start again only after the vehicle
speed exceeds 8 mph (13 km/h).
STARTING AND OPERATING
NOTE:
If the vehicle speed remains below 8 mph

(13 km/h), the Rear View Camera image will be
displayed continuously until deactivated via the
touchscreen button "X", the vehicle is shifted
into PARK, or the ignition is placed in the OFF
position.
The touchscreen button "X" to disable display of

the camera image is made available ONLY when
the vehicle is not in REVERSE.
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle and
its projected backup path based on the steering
wheel position. A dashed center line overlay
indicates the center of the vehicle to assist with
parking or aligning to a hitch/receiver.
Different colored zones indicate the distance to
the rear of the vehicle.
The following table shows the approximate
distances for each zone:
Distance To The Rear Of
Zone
The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft (30 cm - 2 m)
6.5 ft or greater
Green
(2 m or greater)
133
4