JUKI LK-1910 Engineer's Manual page 81

(43) Intermediate presser connection setting : This function is not used with the standard machine.
Function No. : 065
Item : 1 Intermediate presser lifter setting
0
1 to 16
Indication
Item : 2 Setting of the actuator of adjusting the height of intermediate presser This function is not used with
LK-1930. (Set level 2)
0
1 to 16
Indication
Item : 3 Setting of the output at the time of start
LOW
Indication
HIGH
(44) Wiper and thread clamp connection setting : This function is not used with the standard machine.
Function No. : 066
Item : 2 Wiper setting
0
Indication
1 to 16
Item : 3 Thread clamp setting
0
1 to 16
Indication
(45) Inverting clamp connection setting : Use this function without changing the standard setting.
Function No. : 069
Item : 1 Inverting device setting
0
1 to 16
Indication
Function : Setting of the output device of the drive signal of intermediate presser lifter
[Contents] No connection
[Contents] Output of the intermediate presser lifter is set to the terminal
number. By this setting, the signal output device of the intermediate
presser lifter can be freely changed. : Initial setting 3
[Contents] No connection
[Contents] Output of the device for adjusting the height of intermediate presser
is set to the terminal number. By this setting, the signal output device
of the device for adjusting the height of intermediate presser can
be freely changed. : Initial setting 4
[Contents] Active LOW output (When the power is ON, the presser goes up
when the presser signal is in the low level.) : Initial setting
[Contents] Active HIGH output (When the power is ON, the presser goes up
when the presser signal is in the high level.)
Function : Setting of the output device of the drive signal of wiper and thread clamp
[Contents] No connection : Initial setting
[Contents] Output of the feeding frame is set to the terminal number. By this
setting, the signal output device of the wiper can be freely changed.
[Contents] No connection : Initial setting
[Contents] Output of the thread clamp is set to the terminal number. By this
setting, the output device of output signal of the thread clamp can
be freely changed.
Function : Setting of the output device of the drive signal of the inverting clamp
[Contents] No connection
[Contents] Output of the inverting clamp is set to the terminal number. By this
setting, the signal output device of the inverting clamp can be freely
changed. : Initial setting 5
76
− −
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)