JUKI LK-1910 Engineer's Manual page 106

Function No. 31 Feeding frame control (2)
This function sets the release of the feeding frame when the sewing is completed.
Item 1 : Control of the release of the feeding frame at the time of completion of the sewing.
This function sets the operation order when the feeding frame goes up after completing the
sewing.
Set value 0 to 99 (Standard state is all release only.)
Item 2 : This function sets the operation of the feeding frame at the time of completion of the sewing.
(Refer to the table 3 below.)
[Memory switch setting level table 3]
Setting
ATSTART
Monolithic feeding frame
HOLD
Monolithic feeding frame
ATEND
Monolithic feeding frame
Item 3 : Constant lowering function
This function can constantly keep the feeding frame held lowered.
Setting OFF : Standard set value Up/down of the feeding frame is possible.
Setting ON
Kinds of applicable feeding frames
Separate type feeding frame
Separate type feeding frame
Separate type feeding frame
Table 3
: At the time of the origin retrieval, after moving to the point of the sewing
start, or in other cases, the feeding frame is kept lowered. Opening/closing
by pedal is not possible.
−
After completing the sewing, the
feeding frame moves to the point
of the sewing start, and wait in the
state that the feeding frame is kept
up.
After completing the sewing, the
feeding frame moves to the point
of the sewing start, and wait in the
state that the feeding frame is kept
down. The feeding frame is
released by the pedal.
After completing the sewing, the
feeding frame is released.
From the sewing end to the sewing
start, the feeding frame moves
while keeping the feeding frame
held released. After moving to thd
sewing start, wait while keeping
the feeding frame held released.
101
−
Description