JUKI LK-1910 Engineer's Manual page 68

(7) Setting of pattern data reading operation
Function No. : 010
Item : 1 Pattern data reading operation setting
SETUP
Indication
READY
Item : 2 Constant pattern data reading mode setting
OFF
Indication
ON
(8) Pattern read-in order setting
Function No. : 011
Item : 1 Reading-in order setting
FD > STR
Indication
STR > FD
Item : 2 Read-in media setting
FD
PROM
FD > PROM
Indication
PROM > FD
By this setting, read-in speed is increased when using data of floppy or data of PROM.
※ Standard data specifications of the numerical controlled sewing machines for the shoe industry.
(9) Speed change in idling operation
Function No. : 012
Item : 1 Jump speed changing function
OFF
Indication
ON
Function : Pattern data reading operation mode is set.
[Contents] Pattern data can be read under the sewing setting state. (the sewing
LED goes out.) : Initial setting
[Contents] Pattern data can be read under the sewing ready state. (the sewing
LED lights up.)
[Contents] Constant pattern data reading function is inoperative. (The backup
data becomes effective, and if the pattern No. desired is the same,
the pattern data is not read from the floppy disk.) : Initial setting
[Contents] Constand pattern data reading function is operative. (Pattern data
is constantly read from the floppy disk.
Function : ※ This function sets the reading-in order of the SATRA data and
the standard sewing machine data.
[Contents] Retrieval is made in the order of sewing machine data → Satra
data. : Initial setting
[Contents] Retrieval is made in the order of Satra data → sewing machine data.
[Contents] This function retrieves the data of floppy.
[Contents] This function retrieves the data of PROM.
[Contents] This function performs retrieval in the order of data of floppy →
data of PROM. : Initial setting
[Contents] This function performs retrieval in the order of data of PROM →
data of floppy.
Function : This function sets the speed change of the jump speed when the
machine runs idle.
[Contents] The machine performs jumping at a constant speed at all times. :
Initial setting
[Contents] 2-step speed changing function is possible.
While the machine performs jumping of the sewing data, the jump
speed can be decreased by turning ON the pedal switch.
63
− −
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)