JUKI LK-1910 Engineer's Manual page 69

(10) Selection of thread trimming after turning ON the temporary stop switch
Function No. : 013
Item : 1 Thread trimming setting
AUTO
NDL
Indication
STOP
(11) Input command time out
Function No. : 016
Item : 1 Setting of the length of time to wait for external input
0
Indication
0 to 655
(12) Thread trimming command control
Function No. : 018
Item : 1 Setting of effective thread trimming command or ineffective thread trimming command
ON
OFF
Indication
(13) Stop control at the time of the sewing end
Function No. : 019
Item : 1 Stop control setting
OFF
ON
Indication
Function : This function sets the thread trimming operation when operating
the temporary stop switch.
[Contents] Thread trimmer automatically actuates. (When the temporary stop
switch is pressed, the sewing machine temporarily stops as well as
the thread trimmer actuates.)
[Contents] Manual 1 (When the temporary stop switch is pressed, the sewing
machine temporarily stops. In this state, the thread trimmer is
actuated by turning ON "needle threading switch".)
[Contents] Manual 2 (When the temporary stop switch is pressed, the sewing machine
temporarily stops. In this state, the thread trimmer is again actuated by
pressing "the temporary stop switch". At this time, the thread trimmer can
also be actuated by operating "needle threading switch") : Initial setting
Function : This function sets the length of time of the external input command
time out (time to wait for input).
[Contents] There is no time-out. (Time-out of the external input command is
not valid, and the input is being waited forever. It is possible for the
sewing machine to be in the temporary stop state by operating the
temporary stop switch.) : Initial setting
[Contents] Setting of length of time to wait for input (the input is being waited
for the time of this set value x 100 mse. If there is no input, the
sewing machine is in the temporary stop state.)
Function : Setting of effective/ineffective thread trimming command in the
sewing pattern.
[Contents] Thread trimming command is rendered effective. : Initial setting
[Contents] Thread trimming command is rendered ineffective. (In this case,
when the machine temporarily stops, and the needle thread is
broken, the thread trimmer is actuated.)
Function : The machine is temporarily stopped at the end of a sewing pattern.
[Contents] Temporary stop operation at the end of a sewing pattern is rendered
ineffective. : Initial setting
[Contents] Temporary stop operation at the end of a sewing pattern is rendered
effective. At this time, closing/opening of the feeding frame is not
possible. However, tracing of the sewing pattern is possible by the
feed forward/backward key.
The sewing is in the state of the end by depressing the start pedal
at the position of the end.
64
− −
(Set level 1)
(Set level 2)
(Set level 2)
(Set level 2)