JUKI LK-1910 Engineer's Manual page 77

(31) Thread trimming control
Function No. : 044
Item : 1 Device control
OFF
Indication
ON
Item : 2 Feed operation control at the time of thread trimming
ON
Indication
OFF
Item : 3 Needle hole guide diameter setting
16 to 40 (mm)
Indication
(32) Inverting mechanism control : It is effective when using the inverting device (FU02).
Function No. 045
Item : 1 Device control
OFF
Indication
ON
Item : 2 Automatic inversion Y coordinate setting
0 to 999
Indication
( x 0.1 mm)
(33) Bobbin thread replacing device control : It is effective only when the bobbin thread replacing device is attached.
Function No. : 047
Item : 1 Device control
OFF
Indication
ON
(34) Sewing machine speed control 1
Function No. : 050
Item : 1 Soft-start 1
Indication
2 to 9 X 100 r.p.m
Item : 2 Soft-start 2
2 to 25 X 100 r.p.m [Contents] Speed after 1 stitch when the sewing machine is actuated is set.
Indication
Item : 3 Soft-start 3
2 to 25 X 100 r.p.m [Contents] Speed after 2 stitches when the sewing machine is actuated is set.
Indication
Function : Thread trimmer setting
[Contents] Thread trimming operation is not made in any case. (Thread trimming
operation is not made at the time of temporary stop and thread breakage.)
[Contents] Thread trimming operation is made. : Initila setting
[Contents] This function moves cloth (feed) simultaneously at the time of thread
trimming to prevent defective thread trimming. : Initial setting
[Contents] Feed operation is not performed at the time of thread trimming.
[Contents] By setting the inner diameter of needle hole guide used, feed amount at
the time of thread trimming is set to proper amount. : Initial setting 16
Function : Inverting mechanism setting
[Contents] The inverting mechanism control is rendered ineffective. (Even when
an inversion pattern is used, the inverting mechanism control is not
performed.)
[Contents] The inverting mechanism control is performed. : Initial setting
[Contents] Inverting position (coordinate of Y direction) is set when the inversion
is made automatically. (Initial setting 170.)
Function : Bobbin thread replacing device setting
[Contents] Bobbin thread replacing device control is not made. : Initial setting
[Contents] Bobbin thread replacing device control is made.
Function : Starting speed of the sewing machine (start of sewing to after 2
stitches) is set.
[Contents] Starting speed of the sewing machine is set. (Initial setting 2)
(Initial setting 6)
(Initial setting 10)
72
− −
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 2)
(Set level 1)
(Set level 1)
(Set level 1)