JUKI LK-1910 Engineer's Manual page 122

(2)-3 Function No. 3 : Output check function
Operation of the devices can be confirmed by outputting signals to the respective outputs from operation
panel.
1) Select the key when selection of the test mode is
shown.
[Display indication]
OUTPUT CHECK
0 00000000
1 2
2) When depressing the feeding frame switch, the step indication of indication 1 is updated.
By pressing the keys from
[Indication on the dispaly]
™ Step "0"
Output check of air system (No output with the magnet type machine head)
＊ ＊ ＊ ＊
™ Step "1"
Output signal of magnet components is output.
＊ ＊ ＊ ＊
™ Step "2"
™ Step "3"
Output when the optional is attached (Standard type machine does not work.)
1 Step indication Output check is composed of four steps from
0 to 3.
The current step is shown.
2 Input state is shown "0" or "1".
Indication digit changes according to the respective steps.
When the indication is "1", the signal is being output.
to , the keys output signals to the respective output terminals.
＊ ＊ ＊ ＊
Wiper Output by " " key
Feeding frame Output by " " key
Intermediate presser Output by " " key
TENSION DISK Output by " " key
OUTPUT CHECK
0
Feeding frame 1 Output by " " key
Feeding frame 2 Output by " " key
Not used
External output 1 Output by " " key
External output 2 Output by " " key
External output 3 Output by " " key
External output 4 Output by " " key
External output 5 Output by " " key
117
− −
00000000