Adjustment Procedures
Mechanical origin is as shown in the figure on the left side.
In the lateral direction, the center of needle hole, the center of X
feed support shaft and the center of Y feed support shaft become
a straight line.
Fit the point by adjusting 2) Y origin sensor and 3) X origin sensor.
* 1) Select "Test mode No. 2 Origin retrieval". (For LK-1910/20
only)
* 2) Simultaneously pressing
panel, turn ON the power. (For LK-1930 only)
* 3) Press
in the operation panel. (For LK-1930 only)
4) Every time depressing the pedal, the origin is retrieved. Loosen
sensor slit setscrew 1 and shift the position of Y sensor slit 2
to set the feed plate to the position of origin.
(Caution) After the adjustment, make sure that Y sensor slit
2 does not interfere with Y sensor 3.
* : Selection of model
and
in the operation
28
−
−
Results of Improper Adjustment
™ Maximum area cannot be
secured.
™ Distortion of stitching shape will
occur.