Installing Impact Guards/Calf Strap/H-Calf Strap; Installing/Removing Dual Point Armrests (Fixed And Adjustable Height) - Invacare Solara 3G User Manual

4 OPERATION
4.3

Installing Impact Guards/Calf Strap/H-Calf Strap

 Impact guards are standard equipment on Model
ST footrests. No assembly is required.
1. Remove impact guard/calf strap from packaged container.
2. Secure the impact guards to the footrest frame.
3. Secure the calf strap around the footrest frame (with the impact
guards attached).
4.4

Installing/Removing Dual Point Armrests (Fixed And Adjustable Height)

WARNING
Make sure the locking mechanism is secured before using wheelchair.
Installing Armrest
1. Unlock armrest assembly by flipping the arm assembly release lever located on the side rail to the UP (horizontal) position (Detail "A")..

Armrest locks MUST be in the unlocked position when placing arm into the arm sockets.
2. Install armrest assembly into the arm sockets.
3. When installed, lock the armrest assembly by pressing the release lever into the down (vertical) position (Detail "A").
4. Repeat STEPS 1-3 for the opposite side of the wheelchair.
5. For adjustable height dual point armrests, adjust the height if necessary. Refer to Adjusting the Height of the Adjustable Height Armrests on
page 68.
Invacare® Solara®3G/Spree 3G Wheelchair
L
Impact Guard
FIGURE 3 Installing Impact Guards/Calf Strap/H-Calf Strap
38
H-Calf
Strap
Calf Strap
Part No 1154295