Sas Controller Front Retention Brackets - IBM Storwize V7000 Unified Problem Determination Manual

SAS expander card
front retention bracket
Tab
Figure 23. SAS controller front retention brackets
1
2
Figure 24. Removing the rear controller retention bracket
2) Remove the rear controller retention bracket located in the battery bay
above the power supplies by pulling up the release tab 1 and sliding
the bracket outward 2 . See Figure 24.
3) Install the controller retention bracket from step ii by aligning the
retention bracket controller slot and then placing the bracket tabs in the
holes on the chassis, and slide the bracket to the left until it clicks into
place. See Figure 25 on page 122.
121
Chapter 4. File module