IBM Storwize V7000 Unified Problem Determination Manual page 128

3. Press down on the left and right side latches and pull the server out of the rack
4. Remove the cover, as described in "Removing the cover" on page 87.
5. Locate the virtual media key on the system board. Grasp it and carefully pull it
Installing the IBM virtual media key
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To install a virtual media key, complete the following procedure.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Align the virtual media key with the virtual media pins on the system board as
3. Insert the virtual media key onto the pins until it clicks into place.
4. Install the cover, as described in "Installing the cover" on page 88.
5. Slide the file module into the rack.
104
Storwize V7000 Unified: Problem Determination Guide Version
enclosure until both slide rails lock.
off the virtual media connector pins.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
shown in the illustration.