Location Of The Ethernet Adapter Filler Panel On The Chassis - IBM Storwize V7000 Unified Problem Determination Manual

Ethernet adapter
filler panel
Rubber
stopper
Figure 14. Location of the Ethernet adapter filler panel on the chassis
2
2
1
3
1
Figure 15. Location of the port openings on the chassis
10. Align the adapter with the adapter connector on the system board; then, tilt
Standoff
6. Install the two standoffs on the system board.
7. Insert the bottom tabs of the metal clip into the port openings from outside
the chassis. See Figure 15.
8. While you slightly press the top of the metal clip, rotate the metal clip toward
the front of the server until the metal clip clicks into place. Make sure the
metal clip is securely engaged on the chassis.
Attention: Pressing the top of the metal clip with excessive force may cause
damage to the metal clip.
9. Touch the static-protective package that contains the new Ethernet adapter to
any unpainted metal surface on the server. Then, remove the Ethernet adapter
from the package.
the adapter so that the port connectors on the adapter line up with the port
openings on the chassis. See Figure 16 on page 116.
115
Chapter 4. File module