Sas Riser-Card Assembly On Tape-Enabled - IBM Storwize V7000 Unified Problem Determination Manual

Release latch
Pins
SAS riser card
Figure 27. SAS riser-card assembly on tape-enabled server model
Removing the ServeRAID SAS controller from the SAS riser-card
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
A ServeRAID SAS controller is installed in a dedicated slot on the SAS riser card.
Note: For brevity, in this documentation the ServeRAID SAS controller is often
referred to simply as SAS controller.
Slots
a. Align the pins on the backside of the riser with the slots on the side of the
chassis.
b. Align the SAS riser card of the SAS controller assembly with the SAS
riser-card connector on the system board.
c. Press the SAS controller assembly into place; make sure that the SAS riser
card is firmly seated and that the release latch and retention latch holds the
assembly securely.
123
Chapter 4. File module