IBM Storwize V7000 Unified Problem Determination Manual page 319

Table 44. Upgrade error codes and recommended actions (continued)
Error
Code Explanation
01D0 Unable to disable call home.
01D1 Unable to enable call home.
01D2 Failed to stop GPFS.
01D3 Could not determine if backups are
running.
01D5 Storwize V7000
stalled_non_redundant.
01D6 Storwize V7000 system stalled.
01D8 CTDB cluster is unhealthy.
01DA GPFS system is unhealthy.
01DB Failed to stop performance center.
01DC Failed to configure performance
center.
01DD Failed to start performance center.
01DE Unable to communicate with
passive management node.
01DF Upgrade must be resumed from the
other management node.
01E0 HSM upgrade failed.
Action
Contact your next level of support.
Contact your next level of support.
1. Follow SONAS GPFS troubleshooting
documentation.
2. Contact your next level of support.
1. Attempt to stop backups.
2. Type lsjobstatus -j backup;echo $?.
If the return code is 0, start the
upgrade again.
3. If the return code is any other
number, contact your next level of
support.
Refer to Storwize V7000 documentation.
Refer to Storwize V7000 documentation.
1. See "Checking CTDB health" on page
169.
2. Use lshealth or RAS procedures to
determine unhealthy components.
3. Contact your next level of support.
1. See "Checking the GPFS file system
mount on each file module" on page
171.
2. Use lsnode -r to confirm GPFS is
unhealthy. If node GPFS is healthy
restart the upgrade.
3. Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
1. Ensure that the active mgmt node can
communicate with the passive
management node before restarting
the upgrade.
2. Contact your next level of support.
Restart upgrade from other management
node. This might require that a failover
be issued first.
Contact your next level of support.
Chapter 7. Recovery procedures
295