Procedure: Reseating A Node Canister; Procedure: Powering Off Your System - IBM Storwize V7000 Unified Problem Determination Manual

2. Connect the other end of the Ethernet cable directly to the Ethernet port on a
3. Use the operating system tools on the computer to set the IP address of the
4. Point the web browser to the service IP address for the node canister attached
5. Log on with the superuser password. The default password is passw0rd.
6. After the action completes, disconnect your personal computer, and reconnect
7. Set the service address of the canister to one that can be accessed on the

Procedure: Reseating a node canister

Use this procedure to reseat a canister that is in service state or because a service
action has directed you.
About this task
Verify that you are reseating the correct node canister and that you use the correct
canister handle for the node that you are reseating. Handles for the node canisters
are located next to each other. The handle on the right operates the upper canister.
The handle on the left operates the lower canister.
Procedure
10. Verify that the LEDs are on.
Results

Procedure: Powering off your system

Use this procedure to power off your Storwize V7000 Unified system when it must
be serviced or to permit other maintenance actions in your data center. To turn off
the Storwize V7000 Unified system, see "Turning off the system" in the Storwize
V7000 Unified information center.
222
Storwize V7000 Unified: Problem Determination Guide Version
personal computer that has a web browser installed.
Ethernet port that is used in the previous step to 192.168.70.10.
at step 1. If the service IP address has not been changed at any time, use the
default service IP addresses listed in "Problem: Cannot connect to the service
assistant" on page 207.
the node canister to the Ethernet network.
network as soon as possible.
Verify the clustered-system status LED on the node canister. If it is
1.
permanently on, the node is active. If the node is active, no reseating is
required.
2. Verify that you have selected the correct node canister and verify why you are
reseating it. Go to "Procedure: Identifying which enclosure or canister to
service" on page 211.
3. Grasp the handle between the thumb and forefinger.
4. Squeeze them together to release the handle.
5. Pull out the handle to its full extension.
6. Grasp the canister and pull it out 2 or 3 inches.
7. Push the canister back into the slot until the handle starts to move.
8. Finish inserting the canister by closing the handle until the locking catch clicks
into place.
9. Verify that the cables were not displaced.