Replacing The Support Rails - IBM Storwize V7000 Unified Problem Determination Manual

14. Replace the end caps. Use the new right end cap and use the left end cap that
15. Reinstall the drives in the new enclosure. The drives must be inserted back
16. Reinstall the canisters in the enclosure.
17. Install the power supply units.
18. Reattach the data cables to each canister by using the information that you
19. Attach the power cords and the cable retention brackets to the power supply
20. Write the old enclosure machine type and model (MTM) and serial number on
21. Turn on the power to the enclosure by using the switches on the power
Results
The system records an error that indicates that an enclosure FRU replacement was
detected. Go to the management GUI to use the fix procedure to change the
machine type and model and serial number in the expansion enclosure.

Replacing the support rails

This topic describes how to replace the support rails.
About this task
Perform the following steps to replace the support rails:
Procedure
254
Storwize V7000 Unified: Problem Determination Guide Version
you removed in step 9 on page 253.
Using the left end cap that you removed preserves the model and serial
number identification.
into the same location from which they were removed on the old enclosure.
recorded previously.
Note: The cables must be inserted back into the same ports from which they
were removed on the old enclosure; otherwise, the system cannot function
properly.
units.
the repair identification (RID) tag that is supplied. Attach the tag to the left
flange at the back of the enclosure.
supply units.
1. Remove the enclosure.
2. Record the location of the rail assembly in the rack cabinet.
3. Working from the back of the rack cabinet, remove the clamping screw 1
from the rail assembly on both sides of the rack cabinet.