Server Model - IBM Storwize V7000 Unified Problem Determination Manual

To remove the SAS riser-card and controller assembly from the server, complete the
following procedure.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. To remove the SAS riser-card and controller assembly for a 16-drive-capable
SAS controller
SAS riser card
Figure 19. 16-drive-capable server model
3. To remove the SAS riser-card and controller assembly for a tape-enabled server
118
Storwize V7000 Unified: Problem Determination Guide Version
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
server model, complete the following steps.
Figure 19 shows the SAS riser card in the 16-drive-capable server model.
Release tab
a. Press the release tab toward the rear of the server and lift the back end of
the SAS controller card slightly.
b. Place your fingers underneath the upper portion of the SAS riser card and
lift the assembly from the system board.
c. Slide the front end of the SAS controller card out of the retention bracket
and lift the assembly out of the server.
model, complete the following steps.
Figure 20 on page 119 shows the SAS riser card in the tape-enabled server
model.