IBM Storwize V7000 Unified Problem Determination Manual page 172

6. Reach inside the file module and press the release tab; then, while holding the
7. From the front of the file module, carefully pull the operator information panel
8. If you are instructed to return the operator information panel assembly, follow
Installing the operator information panel assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To install the replacement operator information panel assembly, complete the
following procedure.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Slide the operator information panel assembly into the server until it clicks into
3. Inside the server, connect the cable to the rear of the operator information panel
4. Install the cover, as described in "Installing the cover" on page 88.
5. Slide the file module into the rack.
6. Reconnect the external cables; then, reconnect the power cords and turn on the
Removing a microprocessor and heat sink
The following procedure is for a field replaceable unit (FRU). FRUs must be
installed only by trained service technicians.
148
Storwize V7000 Unified: Problem Determination Guide Version
release tab down, push the assembly toward the front of the file module.
assembly out of the file module.
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
place.
assembly.
peripheral devices and the file module.
Note: You must wait approximately 2.5 minutes after you connect the power
cord of the file module to an electrical outlet before the power-control button
becomes active.