IBM Storwize V7000 Unified Problem Determination Manual page 112

Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. If you are planning to view the error LEDs that are on the system board and
3. If you are planning to install or remove a microprocessor, memory module, PCI
4. Press down on the left and right side latches and pull the file module out of
5. Push the cover-release latch back 1 , then lift it up 2 .
6. Slide the cover back 3 , then lift the cover off the file module and set it aside.
7. If you are instructed to return the cover, follow all packaging instructions, and
Installing the cover
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
88
Storwize V7000 Unified: Problem Determination Guide Version
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
components, leave the file module connected to power and go directly to step
4.
adapter, battery, or other non-hot-swap optional device, turn off the file module
and all attached devices and disconnect all external cables and power cords.
the rack enclosure until both slide rails lock.
Note: You can reach the cables on the back of the file module when the file
module is in the locked position.
Attention: For proper cooling and airflow, replace the cover before turning on
the file module. Operating the file module for extended periods of time (over
30 minutes) with the cover removed might damage file modulefile module
components.
use any packaging materials for shipping that are supplied to you.