A.1.1
Assembly of cable terminals/connectors on the drive side
A.1.1.1
Power terminal assembly
SINAMICS
Procedure
V90
200 V variant
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
FSA
•
3. Insert the stripped end into the cable
FSB
•
end sleeve.
FSC
•
4. Crimp the cable end sleeve using a
FSD
•
crimp tool for end sleeves.
400 V variant
FSAA
•
FSA
•
400 V variant
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
FSB
•
3. Insert the stripped end into the spade
FSC
•
terminal.
4. Crimp the spade terminal using a crimp
tool for cable lugs. (Note: Coat any ex-
posed wires with tin.)
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
Illustration
Appendix
A.1 Cable assembly
411