Sound Board - Toshiba Tecra M1 Maintenance Manual

4 Replacement Procedures

4.17 Sound Board

Removing the Sound Board
To remove the sound board, follow the steps below and refer to figure 4-30.
CAUTION: When the sound board is installed on the system board outside of the chassis,
do not connect or disconnect a cable to the headphone or microphone jack repeatedly for
check. Before checking the jacks, install the sound board on the system board, and secure
them with one screw. Otherwise, load might be applied to PJ3000 on the sound board or
PJ1100 on the system board and cause solder crack.
1. Remove the following screw securing the sound board.
M2.5 4
2. Lift up the sound board to disconnect PJ3000 on the back of the sound board from PJ1100
on the system board. Lift up the board toward the side of jacks.
4-56
FLAT HEAD screw 1
TECRA M1 Maintenance Manual (960-436)
4.17 Sound Board