Toshiba Tecra M1 Maintenance Manual page 221

3.29 SETUP
11. PCI Bus
This item displays the interrupt level for the Card Bus. It is for information only and cannot
be changed.
PCI BUS = IRQ11
12. PC Card
This option sets the PC Card Controller mode. This option can be changed when "Device
Config." is set to "All Devices".
Auto-Selected
PCIC Compatible Use this setting for PCIC compatible PC card.
CardBus/16-bit
13. Peripheral
Use this option to select the parallel port mode and hard disk mode.
(a) Internal Pointing Device
This option enables and disables the Touch Pad.
Enabled
Disabled
(b) Ext Keyboard "Fn"
Use this option to set the Fn key equivalent when you are using an external
keyboard. Selecting this option displays the following subwindow.
Enabled
Ext Keyboard "Fn" key equivalent
Use this option to set a key combination on an external keyboard to emulate the Fn
key on the computer's internal keyboard. Setting an Fn key equivalent will enable
TECRA M1 Maintenance Manual (960-436)
Use this setting for all PC Cards when OS supports Plug&Play.
(Default)
Use this setting when CardBus does not work properly in
Auto-Selected", or PC card supports 16-bit.
Enables the Touch Pad. (Default)
Disables the Touch Pad.
Enables the feature.
KEYBOARD
= Left Ctrl + Left Alt
3 Tests and Diagnostics
3-93