Toshiba Tecra M1 Maintenance Manual page 333

4 Replacement Procedure
3. Folding and temporary fixing of TAB/PCB
1) Fold the X-TAB (X-PCB) and Y-TAB (Y-PCB) to the back of backlight unit.
2) Hook the X-PCB on the three latches on the back of frame.
NOTE: Be careful not to damage the TAB.
(1) Fold the X-PCB to the back.
(2) Fold the Y-PCB
to the back.
The PCB shall be hooked on the
three latches of the frame.
The PCB shall not be
installed over the frame.
Figure 4-58 Replacing TOSHIBA fluorescent lamp (XGA) (8)
4-96
4.25 Fluorescent Lamp
Insert the FPC into the connector.
TECRA M1 Maintenance Manual (960-436)