Toshiba Tecra M1 Maintenance Manual page 259

4.8 CPU
M2.5 16 FLAT HEAD screw
M2.5 4 FLAT HEAD screw
2. Remove the following screws securing the CPU holder. Lift the "2" side of the CPU holder
first, then rotate the holder 90 degrees counterclockwise. Then lift the "1" side of the CPU
holder and remove the holder.
M2 6
3. Remove the fin.
CAUTION: Silicon grease is applied between the fin and the CPU. When
removing the fin, be careful not to damage the CPU under the fin.
TECRA M1 Maintenance Manual (960-436)
Figure 4-11 Removing the CPU cover
BIND screw
M2.5 4 FLAT HEAD screw
A
Slot
4
4 Replacement Procedures
CPU cover
4-29