Toshiba Tecra M1 Maintenance Manual page 287

4.16 LED Board
Installing the LED Board
To install the LED board, follow the steps below and refer to figure 4-29.
1. Connect the LED board SUMI card to PJ3100 on the LED board.
2. Place the LED board and secure it with the following screws.
M2.5 4
3. Connect the LED board SUMI card to PJ1101 on the system board.
4. Stick the glass tape to secure the LED board SUMI card and USB cable.
TECRA M1 Maintenance Manual (960-436)
FLAT HEAD screws
4 Replacement Procedures
2
4-55