4.12 Touch Pad
Installing the Touch Pad
To install the touch pad, follow the steps below and refer to figures 4-20 to 4-22.
1. Connect the touch pad SUMI card to CN1 on the touch pad.
2. Install the touch pad and touch pad switches on the palm rest and pass the touch pad SUMI
card into the hole of the palm rest. Secure them with the following screws.
M2.5 4
M2.5 4
3. Place the palm rest on the display assembly and secure the latches by pressing it. Secure the
palm rest with the following screw.
M2.5 4
4. Connect the touch pad SUMI card to PJ2003 on the system board.
5. Close the display panel and turn the computer face down. Secure the palm rest with the
following screws to the display assembly.
M2.5 4
M2.5 6
M2.5 10 FLAT HEAD screw
M2.5 16 FLAT HEAD screw
TECRA M1 Maintenance Manual (960-436)
FLAT HEAD screw
TAPPING screw
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
4 Replacement Procedures
2
2
1
2
3
2
2
4-43