Toshiba Tecra M1 Maintenance Manual page 222

3 Tests and Diagnostics
you to use "Hotkeys" by pressing the set combination in place of the Fn key. The
following items can be selected for this option:
Left Ctrl + Left Alt*
Right Ctrl + Right Alt*
Left Alt + Left Shift
Right Alt + Right Shift
Left Alt + Caps Lock
*If these selections are made, you cannot warm boot the system by pressing Ctrl +
Alt + Del.
Disabled
(c) Parallel Port Mode
The options in this tab are ECP and Standard Bi-directional.
ECP
Std. Bi-Direct.
(d) Hard Disk Mode
Use this item to select the hard disk mode.
Enhanced IDE
(Normal)
Standard IDE Select this mode when using an operating system that does not
NOTE: Formats for Enhanced IDE and Standard IDE are different, so if
you change the setting, you will have to reformat the hard disk for the
appropriate setting.
14. Legacy Emulation.
(a) USB keyboard/Mouse Legacy Emulation.
Use this option to enable or disable USB KB/Mouse Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse and
keyboard by setting the USB KB/Mouse Legacy Emulation item to Enabled.
Enabled
3-94
Disables the feature. (Default)
Sets the port mode to Extended Capabilities Port (ECP). For most
printers, the port should be set to ECP. (Default)
This setting should be used with some other parallel devices.
Select this mode when using an operating system that
supports Enhanced IDE. (Default)
support Enhanced IDE.
USB Legacy Support can be used. (Default)
TECRA M1 Maintenance Manual (960-436)
3.29 SETUP