Toshiba Tecra M1 Maintenance Manual page 336

4.25 Fluorescent Lamp
6. Sticking tapes and insulation sheets
1) Stick the Y-PCB insulation sheet and X-PCB insulation sheet in order.
2) Stick the two bezel tapes on the lower side (lamp side).
3) Stick the fixing tape for FL cable.
NOTE: Be careful not to damage to the TAB or the pulling-out part of lamp
cable when sticking the tapes and insulation sheets.
Stick the X-PCB
insulation sheet.
Stick the insulation sheet
without any flexure.
Stick the bezel tape while pressing
not to cause floating of bezel.
Figure 4-61 Replacing TOSHIBA fluorescent lamp (XGA) (11)
TECRA M1 Maintenance Manual (960-436)
Stick the Y-PCB
insulation sheet.
Bezel tape
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
4 Replacement Procedure
Stick the insulation sheet
without any flexure.
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
Standard for fixing
tape for FL cable.
Fixing tape for FL cable
4-99