Toshiba Tecra M1 Maintenance Manual page 145

3.6 Keyboard Test
To check only the USB mouse, follow the procedures below:
Connect the USB mouse to the computer's USB connector.
Next, set up the computer's hardware as follows:
PERIPHERAL
Then, perform the Pointing Stick Diagnostic Test and make sure:
To stop this test, press the two IPS buttons on the computer at the same time. (You
cannot use the USB mouse to stop the test.)
Subtest 05 USB Test
This Subtest checks USB. The USB TEST Module (ZD0003P01) and USB Cable
(ZD0003P02) must be connected to the computer.
The following message will appear. Select a port to test and press Enter.
Test port number select (1:Port0, 2:Port1, 3:Port2) ?
If the test ends successfully, OK is displayed. If nothing is displayed, there may be a
problem with the USB port. Check the wraparound connection and repeat the test.
Subtest 07 InTouch/Presentation key
When this subtest displays messages shown below in order, press the
corresponding button.
NOTE: This subtest must be completed within 10 seconds.
TECRA M1 Maintenance Manual (960-436)
Internal Pointing Device = Simultaneous
USB Legacy Emulation = Enabled
The cursor moves in the direction that you move the USB mouse.
The display reverses when you click the right button or left button
Press [ InTouch ] key
Press [ Presentation ] key
3 Tests and Diagnostics
3-19