Toshiba Tecra M1 Maintenance Manual page 343

4 Replacement Procedure
6. Install the lamp cover (F) and secure it with the two screws (E).
NOTE: Be careful not to make the lamp cover over the fitting pin. Around the
pulling-out part of the lead wire, attach so that the P chassis is outside.
Figure 4-67 Replacing Sharp fluorescent lamp (SXGA+) (6)
4-106
(E)
4.25 Fluorescent Lamp
Screw tightening torque:
0.1176N m (1.2kgf cm)
(F) Lamp cover
TECRA M1 Maintenance Manual (960-436)
(E)