Infocenter Display - Toro Reelmaster 5410 Series Service Manual

InfoCenter Display

Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
g190807
1.

InfoCenter display

The InfoCenter display used on your Reelmaster is a LCD device that is located
on the control arm (Figure
operator during the operation of the machine, provides the electrical system
diagnostic assistance for the technicians, and allows inputs for the adjustable
machine settings (Figure
The power for the InfoCenter is available when the main power relay is energized
(key switch in the R
UN
machine TEC, Yanmar engine ECU (if equipped), InfoCenter, and cutting unit
motors provide necessary machine communication for the InfoCenter operation.
Note: Icons that are used on the InfoCenter display are identified in the Traction
Unit Operator's Manual.
Figure 197
2. Control arm
197). The InfoCenter provides information to the
198).
or S position). A CAN-bus system involving the
TART
Page 7–9 Electrical System: InfoCenter Display