Fuel Pump (Machine With Kubota Diesel Engine) - Toro Reelmaster 5410 Series Service Manual

Fuel Pump (Machine with Kubota Diesel Engine)

Testing the Fuel Pump Capacity
Electrical System: Testing the Electrical Components
g228839
1. Fuel pump
2. Fuel/water separator
On a machine with a Kubota diesel engine, the fuel pump is attached to the
inside of the left side frame rail near the fuel tank
When testing fuel pump, ensure that pump is not operated without
fuel.
Because diesel fuel is highly flammable, use caution when handling
it. Do not smoke while testing the fuel pump. Do not test fuel pump
while engine is hot. Ensure that there is adequate ventilation when
testing. Always wipe up any spilled fuel before starting the engine.
1. Park machine on a level surface, lower cutting units, shut off the engine
and set the parking brake. Remove key from key switch. Raise operator
seat and hood.
2. Disconnect wire harness electrical connector from the engine fuel stop
solenoid to prevent the engine from starting; refer to
(Machine with Kubota Diesel Engine) (page
3. Ensure fuel supply hoses attached to the fuel pump and fuel sender in fuel
tank are free of obstructions.
Figure 277
3. Inlet fitting
4. Fuel supply hose
IMPORTANT
DANGER
Page 7–110
(Figure 277).
Engine Run Solenoid
7–100).
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C