Toro Reelmaster 5410 Series Service Manual page 56

Removing the Engine
Kubota Diesel Engine: Service and Repairs
Note: The engine removal and installation procedure is similar for all models
with a Kubota diesel engine.
1. Park machine on a level surface, lower cutting units, stop engine and remove
key from the key switch. Chock wheels to keep the machine from moving.
Open hood.
2. If engine is to be disassembled, drain oil from engine.
3. Disconnect negative (-) and then positive (+) battery cables from the battery.
Do not open radiator cap or drain coolant if the radiator or engine is
hot. Pressurized, hot coolant can escape and cause burns.
Ethylene-glycol antifreeze is poisonous. Dispose of coolant properly,
or store it in a properly labeled container away from children and pets
4. Drain coolant from radiator; refer to
5. Remove air cleaner assembly from machine; refer to
(page 3–8).
6. Remove exhaust system from machine; refer to
g229067
1. Throttle cable swivel
2. Locknut
7. Remove throttle cable from injector pump
A. Remove Bolt that secures throttle cable end to swivel in speed control
lever.
B. Loosen throttle cable clamp (item 4 in
clamp. Slide throttle cable end from swivel.
C. Remove cable clamps that secure throttle cable to engine and driveshaft
brackets. Position throttle cable away from the engine.
8. Disconnect hoses from engine:
CAUTION
Radiator Assembly (page
Figure 22
3. Cable stop
4. Throttle cable clamp
(Figure
Figure
Page 3–22
3–17).
Air Cleaner Assembly
Exhaust System (page
5. Cable clamp (2 each)
6. Throttle cable
22):
22) and remove cable from
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
3–11).