Steering Cylinder - Toro Reelmaster 5410 Series Service Manual

Steering Cylinder

g217320
1. Steering cylinder
2. O-ring (2 each)
3. 90° hydraulic fitting (2 each)
4. O-ring (2 each)
5. Hydraulic hose
6. Hydraulic hose
7. 90° grease fitting
Removing the Steering Cylinder
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
8. Retaining ring
9. Ball joint
10. Rear axle
11. Jam nut (2 each)
12. Slotted hex nut
13. Cotter pin
14. Washer
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
Figure 188
15.
16.
17.
18.
19.
20.
6–145).
Page 6–227
Right drag link
Seal
Hex nut
Ball joint
Grease fitting
Bolt
Hydraulic System: Service and Repairs