Servicing The Front Wheel Motor - Toro Reelmaster 5410 Series Service Manual

Servicing the Front Wheel Motor

g186198
1. Bolt (7 each)
2. End cap
3. O-ring (3 each)
4. Geroler assembly
5. Valve plate
6. Thrust bearing
7. Bearing
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
8. Valve
9. Dowel pin (4 each)
10. Balancing ring
11. Bearing
12. Grease seal
13. Housing
14. Shaft seal
Note: The front wheel motors of your Reelmaster machine are Eaton Delta
motors of the same basic design with minor differences. The right side motor
has a reverse timed manifold to allow correct rotation direction for forward and
reverse. The left side wheel motor can be identified by the machined groove
on the end of the output shaft.
Note: For the front wheel motor repair procedures; refer to the Eaton Delta
Motors Parts and Repair Manual at the end of this chapter.
Figure 158
15.
16.
17.
18.
19.
20.
21.
Page 6–177
Bearing race (2 each)
Thrust bearing
Output shaft
Drive
Back-up ring (2 each)
O-ring
Valve spring
Hydraulic System: Service and Repairs