Programming Busy Line Setting - Northern Telecom Compact ICS 4.0 Manual

¤‹fl›fl
154 / Programming Hunt Groups
3. Press
Terminals&Sets
'
4. Press
prgrming
≠
≠
5. Press
6. Press
≠
7. Enter the Hunt Group number you want to program (1-6).
'
8. Press
9. Press
CHANGE
10. Press
9, 10
®
.
11. Press

Programming busy line setting

A Hunt Group is considered busy if one of two scenarios
exists:
• all of its members are being presented an incoming Hunt
Group call
• all of its members are active on a Hunt Group call
There are three routing options if all members are busy:
• BusyTone—the caller gets a busy tone
• Overflow—the call is routed to an overflow position
• Queue—the call stays in the system for a period of time.
Within this period of time, the call is presented to a
member if one becomes available. When the time-out
occurs, the call is presented to an overflow position.
1. Place the programming overlay on any M7310 or M7324
telephone.
Compact ICS 4.0 System Coordinator Guide
(ADMIN). The display shows
.
until the display shows
.
. The display shows
. The display shows
. The display shows
until the display shows
to select the setting:
'
to exit or
System
Hunt groups
Show group
Member DNs:
Hunt delay
1, 2, 3, 4, 5, 6, 7, 8,
to continue programming.
P0881596 Issue 02
.
.
.
.