Changing User Speed Dial - Northern Telecom Compact ICS 4.0 Manual

142 / User Preferences
Use the display buttons to change the programming for a
button. User Preferences programming cannot change the
buttons that are used by lines, intercom, and the handsfree
feature.
The display buttons used in button programming
CANCL
CLR
TEL#
CHANGE
FEATR
FIND
LIST
Information about individual displays you may see is
described at the end of this section.
≠

Changing User Speed Dial

1. Press
'
the number of speed dial codes that are available.
'
2. Press
≠
3. Press
4. Press
CHANGE
5. Press
way you would dial it on the telephone.
OK
6. Press
Compact ICS 4.0 System Coordinator Guide
Moves you out of a setting without making any changes to it.
Erases the button.
Programs the key as an autodial number for an internal or an
external number. If it is an external autodial number, you
have to choose a line, line pool, or the routing table for the
call to use.
Used when you are setting up an external autodial number.
CHANGE
Press until you see the type of line or pool you want
the number to use.
Press to store a feature code on the button.
Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press
through the list and press
want to program on the button.
User Speed Dial
at
to see the first speed dial code (71).
to move through all the speed dial codes.
at the code you want to change.
and enter the telephone number the same
.
'
OK
when you see the feature you
. The display shows
to move
P0881596 Issue 02