Finishing Paper From 4,000-Sheet Finisher; Finishing Paper From Paper Output Tray For Banner - Kyocera Taskalfa Pro 15000c Operation Manual

Finishing Paper > Finishing Paper

Finishing Paper from 4,000-sheet Finisher

Paper is output to Tray A or Tray B, depending on the size and type of the paper. For A4 size, up to 100 sheets can be
stapled. When the optional Punch Unit is installed, punch holes can be opened.
IMPORTANT
When the index paper is output from a 4,000-sheet Finisher designated as the paper output, the back side of
paper is reversed. You can avoid this behavior by changing the paper output to the Right tray, using the
printer driver or Fiery controller.
NOTE
For the specifications of the 4,000-sheet Finisher and Punch Unit, refer to the following section.
4,000-sheet Finisher (DF-9100) (page 20-13)
Hole Punch Unit for 4,000-sheet Finisher (PH-7A/7C/7D) (page 20-13)

Finishing Paper from Paper Output Tray for Banner

The Paper Output Tray for Banner can be installed on the 4,000-sheet Finisher. Banner Paper up to 700 mm in length
can be output continuously. Output Banner Paper longer than 700 mm one sheet at a time.
Stacker Top Tray
8-8