Priority Override; Repeat Copy - Kyocera Taskalfa Pro 15000c Operation Manual

Using Various Functions > About Functions

Priority Override

Advanced
Copy
Setup
Suspends the current job and gives a new job top priority.
The suspended job resumes after the other job is finished.
(Value: [Off] / [On])
NOTE
• This function is not available if current job was an override.
• Priority override may not be available depending on the status of the current print job and memory usage.

Repeat Copy

Advanced
Copy
Setup
Enables additional copies in the desired quantity as necessary after a copy job is completed.
For confidential documents, you can set up a password for the use of Repeat Copy. In such a case, the correct
password must be entered to perform Repeat Copy.
To register a password, enter a 4-digit password.
IMPORTANT
• A Repeat Copy job is cleared when the power switch is turned off.
• If you forget the password, Repeat Copy cannot be performed for that document. Make a note of the
password beforehand if necessary.
(Value: [Off] / [On])
Repeat Copy is not available when the machine is equipped with the optional Data Security Kit.
When the maximum number of Repeat Copy jobs to retain in the document box is set to 0 (zero), this function cannot be
used.
Repeat Copy Job Retention (page 15-44)
You can select Repeat Copy as the default setting.
Repeat Copy (page 15-36)
Giving a file name to a copy job will facilitate identification of the data when copying.
File Name Entry (page 13-45)
Repeat Copy
The Repeat Copy jobs are stored in the Job Box. Refer to Outputting Repeat Copy Jobs to print out the Repeat Copy
jobs.
Outputting Repeat Copy Jobs (page 12-20)
Functions
Custom
Box
Functions
USB
Memory
13-46