Kyocera Taskalfa Pro 15000c Operation Manual page 161

Using Paper Catalog > Operation When Fiery Controller is Installed
3
4
5
Measure the correction value for the leading edge of the paper.
Check scale "MS1", and find the value of the location where the black lines and red lines align.
In the example below, the lines align at -1, so "-1" is the correction value.
MS1
Measure the correction value for the trailing edge of the paper.
Check scale "MS2", and find the value of the location where the black lines and red lines align.
In the example below, the lines align at 0, so a correction value is not needed.
MS2
NOTE
The scale "MS2" may not be printed depending on the paper size used. In this case, you do
not have to enter the correction value for the trailing edge of the paper.
Enter the correction value.
1
[System Menu/Counter] key > [Device Settings] > [Paper Feeding] > "Cassette
Settings" [Cassette 1 (to 8) Settings] > [Paper Catalog]
2
Select the paper brand > [
Speed]
3
Enter the adjustment value for the leading edge of the paper found in step 3.
4
Enter the adjustment value for the trailing edge of the paper found in step 4.
5
[OK] > [Close]
] (information icon) > "Adjustment Items" [Adjust Motor
5-20