Network Setup - Kyocera Taskalfa Pro 15000c Operation Manual

Installing and Setting up the Machine > Network Setup

Network Setup

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
Set up TCP/IP (IPv4) to connect to the Windows network.
Be sure to connect the network cable before configuring the settings.
Connecting Network Cable (page 3-3)
The configuration methods are as follows:
Configuration Method
Configuring the Connection
from the Operation Panel
on This Machine
Configuring Connections
on the Web Page
For other network settings, refer to the following:
Network Settings (page 15-46)
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user name and login password are both set as 15000.
IPv4 setting
1
2
Use Quick Setup Wizard when configuring the
network in a wizard-style screen, without setting
individually in System menu.
For the equipped network interface, the connection
can be set by using Command Center RX.
Display the screen.
[System Menu/Counter] key > [Network Settings] > [Wired Network Settings] > [IPv4
Settings]
Configure the settings.
When using DHCP server
• [DHCP]: Set to [On].
When setting the static IP address
• [DHCP]: Set to [Off].
• [Auto-IP]: Set to [Off].
• [IP Address]: Enter the address.
• [Subnet Mask]: Enter the subnet mask in decimal representation (0 to 255).
• [Default Gateway]: Enter the address.
When using the Auto-IP
Enter "0.0.0.0" in [IP Address].
When setting the DNS server
In the following cases, set the IP address of DNS (Domain Name System) server.
Description
3-11
Reference Page
Quick Setup Wizard (page 3-
13)
Command Center RX User
Guide