Kyocera Taskalfa Pro 15000c Operation Manual page 317

Using Various Functions > About Functions
Punch
Punches holes in sets of finished documents.
NOTE
• This function requires the optional 4,000-sheet Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Hole Punch Unit for 4,000-sheet Finisher (PH-7A/7C/7D) (page 20-13)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item
Punch Off
2 holes Left
2 holes Top
2 holes Right
4 holes Left
4 holes Top
4 holes Right
Original Top Edge on Top, Top Edge on Left,
Orientation Auto
Original Orientation and Punch Hole Position
Original
Value
Image
Print results
Select the position of punch holes. For details on original
orientation and position of punch holes, refer to the
following:
Original Orientation and Punch Hole Position (page
13-9)
Select the orientation of the original document top edge
to scan correct direction. Select [Original Orientation]
to choose orientation of the originals, either [Top Edge
on Top] or [Top Edge on Left]. Then select [OK].
Original orientation
Glass platen
13-9
Description
Document processor