Removing And Replacing The Disk Drive And Fan Card In The 8335-Gtb - IBM Power System S822LC Manual

Figure 48. Disk drive lock detail
4. Configure the installed drive for your environment.
After you insert the new drive, you need to rescan for the device.
v Ubuntu Linux operating system: To run the rescan-scsi-bus command in the Ubuntu Linux
operating system, log in to the system as the root user, and run the following command:
rescan-scsi-bus
The rescan-scsi-bus tool is available in the scsitools package; install the package by using the
following command:
sudo apt-get install scsitools
v Red Hat Enterprise Linux (RHEL) version 7.2: To run the rescan command in the REHL version 7.2
operating system, log in to the system as the root user, and run the command:
rescan-scsi-bus.sh -a
The rescan-scsi-bus tool is available in the sg3_utils package; install the package by using the
following command:
yum install sg3_utils
You may also want to refer to: Adding a Storage Device or Path (https://access.redhat.com/
documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Storage_Administration_Guide/
adding_storage-device-or-path.html)
Verify that the new drive is active with the following command:
lsscsi
5. Load or restore data from your backup media.

Removing and replacing the disk drive and fan card in the 8335-GTB

Learn how to remove and replace the disk drive and fan card in the IBM Power System S822LC
(8335-GTB) system.
38
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)