IBM Power System S822LC Manual page 24

Figure 9. The cold plate holder slots and the cold plate pins. Each plastic holder has two slots to secure the two pins
that are on the top of each cold plate. (A) First secure one pin to the holder, then (B) rotate the holder to secure the
second pin. In (C) both pins are secured to the holder.
Now continue with the removal steps.
Figure 10. Fastening the water hoses to the carrier. The carrier has a hook-and-loop fastener to hold the water hoses
when you are moving the entire cold plate assembly and carrier.
7. Open the hook-and-loop fastener on the cold plate installation carrier as shown in Figure 11 on page
9. It holds the water hoses.
8
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)