IBM Power System S822LC Manual page 71

Figure 65. Removing the front USB cable and the power switch and cable from the system backplane and the disk
drive and fan card
6. Pressing the latch release on the connector, disconnect the power switch and cable (B) from the
system backplane. See Figure 65.
7. Remove the rack installation support from the side of the system. See Figure 66
Figure 66. Removing the rack installation support
8. Remove the top and side screws from the power switch. See Figure 67 on page 56.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
55