Table of Contents
Advertisement
Figure 69. Removing the disk drive and fan card
11. Place the disk drive and fan card on the table.
Replacing the disk drive and fan card in the 8335-GTW or 8335-GTX system
To replace a disk drive and fan card, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the replacement disk drive and fan card from the protective plastic envelope.
3. Using the alignment pins (one on each side) (A) for the disk drive and fan card (B), lower and pivot the
card into place.
See Figure 70 on page 75.
Note: Both the front USB cable and the power switch cable (A) need to be located in the recessed
area (B) of the disk drive and fan card. If they are not located in that recessed area, they can be
pinched and damaged. See Figure 71 on page 76.
74 Power Systems: Servicing the 8335-GTW
Advertisement
Table of Contents
