Replacing The Front Usb Cable And Connector In The 8335-Gtb - IBM Power System S822LC Manual

Figure 69. Removing front USB cable and connector from power switch
11. Place the front USB cable and connector and the power switch and cable on the table.

Replacing the front USB cable and connector in the 8335-GTB

Follow these steps to replace the front USB cable and connector in the IBM Power System S822LC
(8335-GTB) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Find the replacement front USB cable and connector and remove it from the protective plastic
envelope.
3. While pressing in the latches (A), connect the front USB cable and connector to the power switch. See
Figure 70.
Figure 70. Attaching the front USB cable and connector to the power switch
4. Insert the front USB cable and the power switch and cable into the system. Be careful to route the
cables through to the system backplane. See Figure 71 on page 58.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
57