IBM Power System S822LC Manual page 87

Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
Remove:
2. Locate the memory riser that contains the failed memory DIMM. Figure 86 shows the location of the
memory risers in the 8335-GTB system and Figure 87 on page 72 shows the DIMM slot locations on
the riser.
Figure 86. Location of the memory risers; positions 9 through 16
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
71