IBM Power System S822LC Manual page 175
Hide thumbs
Also See for Power System S822LC:
- Servicing (146 pages) ,
- Installing the system and ordered parts (140 pages) ,
- Technical overview and introduction (80 pages)
Table of Contents
Advertisement
Figure 182. Removing dust and debris from the system processor module area
5. Prepare the system processor module for removal.
a. Using the supplied removal tool (part number 01AF101), align the beveled corner (A) of the tool
over the beveled corner of the system processor module as shown in Figure 183 on page 160.
b. Lower the tool over the system processor module by ensuring the two guide pins (C) are inserted
into the alignment holes (B) on each side of the tool.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
159
Advertisement
Table of Contents
