Replacing Memory Risers In The 8335-Gtb - IBM Power System S822LC Manual

Figure 93. Removing a memory riser from the system
b. Pull out the memory riser from the slot by holding onto the latches.
c. Place the memory riser on an ESD mat.
4. If applicable, move the memory DIMM from the removed riser onto the replacement memory riser.
For instructions, see "Removing and replacing memory DIMM in the 8335-GTB" on page 70.

Replacing memory risers in the 8335-GTB

Learn how to replace memory risers in the IBM Power System S822LC (8335-GTB) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. To replace the memory riser, complete the following steps:
a. Ensure that the release latches are open to about a 60-degree angle as shown in Figure 94 on page
78.
b. Align the memory riser with the connector.
c. Press the memory riser firmly into the connector.
d. Press the release latches into the closed position. See (A) in Figure 94 on page 78.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
77